DEI Heat Sheath - 1"x36" Panel can be mounted directly

Panel can be mounted directly to your dash or to your roll bar with Mounting Brackets LON-52-22783 or LON-52-22787

Replacement shaft for WM251 24" extended slider

Bolt in short rear spring cup 2-1/2" tall

Fits all WM84 series shifters

Axle clamp is 3/4" wide and the caliper plate is 3/8" thick for superior strength

DEI Heat Sheath - 1"x36" Panel can be mounted directlyHeat Sheath is made from a Hi Temp fiberglass fabric bonded to an aluminized material then sewn into a tube. Designed to slide over wires and hoses this product can be easily shaped to fit the tightest bends. The Heat Sheath will reflect up to 90% of the radiant heat and can insulate against up to 500 degrees direct continuous heat. Easily cut to length with scissors or a sharp knife. Reflects heat from wiring and hoses